Resin Cable Joints

Short Description:

These in-line Resin Cable Joints are for underground, above ground or underwater cable jointing applications. SENTUO cable joints suitable for straight jointing armoured polymeric cables, stranded copper conductors, with crimped connectors. Cable joints feature injection mould, torpedo shells with snap-lock design.. The tunnel construction environment and the cable installation is complicated require the specialized product. Optimum Design of the installation and the cable joints of the product makes it more easier to install and operate. This is suitable for the main line of less than 30mm, branch line less than 25mm.

Send email to us

Product Detail

Product Tags

Product Introduction

1. To joint the cables with Opposite nozzle or other method, Insulation treatment of phase line in case of the short circuit

2. With the size of cable outer diameter, the marks at each ends should be cut off for the Subsequent installation

3. Bind the sponge strip around the each end of the cable. The specific part is the same as the access point of the two ends.

Lock the junction box and make sure each clips is fastened.

Bind the ends of the junction box with the 20# opp bag to avoid resin leakage.

4. Make the resin according to Resin instruction, fill the resin in the box untill the resin curing and cover the lid. Installation is complete.

Appendix: Instructions for use of edge waterproof sealant

Instruction of resin. (Please Strictly abide by the instruction, We are not responsible for all consequences caused by violating the following operation methods)

First open the spacer between component A and component B resin,mixing it well 2 to 3min .
Pour the mixed resin into the branch box Immediately. The resin will cure if not.
The resins avoid contact with skins and eyes